SNAX Creator-2 Configuration and Control Manual

INFO SUBSYS Command Displays
SCF Commands for SNAX Creator-2
117143 SNAX Creator-2 Configuration and Control Manual 4–31
INFO SUBSYS Display
The following example shows the request for information about the SNAX Creator-2
subsystem named $CRE1:
INFO SUBSYS $CRE1
The following display is returned:
SNAX/CRE INFO SUBSYS: $CRE1
Primary CPU................. 0
*Backup CPU.................. 1
Configuration File Name..... \NODE.$DATA.DATA.CONF1
*EMS Collector............... -
*EMS Collector-1............. -
*EMS Collector-2............. -
*EMS Collector-3............. -
*LOG File Name............... \NODE.$TG0.#T3
*MSG File Name............... \NODE.$SYSTEM.SYSTEM.CREMSGS
MSG File Last Modif......... 19 Sep 1992, 10:49:55.270
Program File Name........... \NODE.$SYSTEM.SYSTEM.CREOBJ
Program File Last Modif..... 18 Mar 1993, 23:47:08.080
Buffer Swap Volume.......... $DATA
Memory Swap Volume.......... $DATA
A dash (-) in the field value column indicates that a field is undefined. An asterisk (*)
before an attribute field indicates a configurable attribute. The detailed display is the
same as the nondetailed display, except for showing DETAILED in the header line.
Primary CPU
displays the number of the CPU in which the primary process is running.
Backup CPU
displays whether a backup CPU exists and, if so, gives the number of the CPU in
which the backup process is running.
Configuration File Name
displays the name of the file that contains the configuration database. This file
name correlates to the information specified in the CONFIG parameter of the
SNAX Creator-2 RUN command, or to the temporary file chosen by
SNAX Creator-2 if the CONFIG parameter was not specified in the RUN
command.
EMS Collector
displays the name of the collector process assigned for the collection of EMS
events.