SNAX/APC Application Programming Manual

Application Prototype Simulator

SNAX/APC Application Programming Manual—138786

4-10

DEACTIVATE-SESSION (SF2)

The DEACTIVATE-SESSION verb deactivates an LU-LU session.

DEACTIVATE-SESSION completes immediately; it does not wait for the deactivation

to complete.

As noted earlier, the form of the verb used is that applicable to an IPC with a version

code of S2 or S3.

To use the DEACTIVATE-SESSION verb, the TP that APS represents must have session

control authorization. Session control authorization is determined by the value assigned

to the SESSIONCONTROL attribute of the TP. Only a TP with a value of YES for this

attribute can activate a session. The SCF mnemonic for the TP is TPN, and the attribute

is set when the TPN object is added or subsequently altered.

Request Fields

Session ID

specifies the ID of the session that is to be deactivated. The session ID may be

obtained by issuing a GET-ATTRIBUTES against the conversation (before the

conversation terminates).

Type (No,CL)

specifies the type of deactivation. You can enter one of the following two values:

specifies that the session is to be deactivated normally. If a conversation is

active, deactivation waits until the conversation is deallocated. Deactivation

occurs immediately if no session is active.

SNAX/APC Application Prototype Simulator (APS) System (T9096D30 15FEB95 21c)

Request: Deactivate_Session Resource ID: 1 0 0 1 0 0

Session ID: 1

Type (NO,CL): NO

Reply: Deactivate_Session

IPC Return Code: 0 IPC Ok

IPC Return Code Detail: 0 IPC Ok

UOWs In: 0001 UOWs Out: 0001

Header Return Code: 0 RC Ok

Request Completed

F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12 F13 F14 F15 F16

TPR Aloc Deal TPE R&W RTS SD SE Cnf Cnfd GA Send Prnt Hex Rcov Exit

ActS Dact PRcv RcvI Flsh Gtyp GTP A(T) E(T) Exit