SNAX/APC Application Programming Manual

Application Prototype Simulator
SNAX/APC Application Programming Manual—138786
4-71
Verbs Specific to Tandem Products
Verbs Specific to Tandem Products
The following verbs have been created exclusively for the use of SNAX/APC. There is
no functional equivalent in the IBM option sets. Note that the DISPLAY-STATUS verb
is not supported in the APS because it cannot be used with IPC version code S3, which
APS uses exclusively.
TP-END (F4)
The TP-END verb releases all resources allocated to the local TP by a previous
TP-READY verb. When a local TP has finished using a particular SNAX/APC LU, the
local TP should issue a TP-END verb to release all allocated resources.
A local TP can issue a TP-END verb anytime after a TP-READY verb. However, if a
conversation is active when the local TP issues the TP-END verb, SNAX/APC
deallocates the conversation abnormally.
Request Fields
The TP-END verb screen has no request fields.
Reply Fields
IPC Return Code
displays the value of HEADER-RETURN-CODE returned in the IPC header reply.
SNAX/APC Application Prototype Simulator (APS) System (T9096D30 22JUN95 F15)
Request: TP_End Resource ID: 0 0 0 0 0 0
Reply: TP_End
IPC Return Code: 0 IPC Ok
IPC Return Code Detail: 0 IPC Ok
UOWs In: 0001 UOWs Out: 0001
Header Return Code: 0 RC Ok
Request Completed
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10 F11 F12 F13 F14 F15
F16
TPR MAl MDal TPE MR&W MRTS MSD MSE MCnf MCfd MGA MSnd Prnt Hex Rcov
Exit
ActS Dact MPrc MRcI MFls Gtyp GTP A(T) E(T)
Exit