SNAX/APC Configuration and Management Manual

Configuring Network Resources for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
4-31
SNAX/XF or SNAX/CDF Example
=========================================================================
== Add local LU for remote node $APC2. The SNAXFILENAME names a ==
== second SNAX/APN line. The subdevice name must match SNANAME. ==
=========================================================================
add lu rlu01, snaname rlu01, snaxfilename $nt21b.#rlu01, &
maxsession 1024, autostart yes
=========================================================================
== Add a partner LU for the remote node. ==
=========================================================================
add ptnr-lu rlu01.llu01, snaname llu01, peripheral-node yes, &
parallel-session-lu yes
=========================================================================
== Add the mode name, LU62BIND, to the LU. ==
=========================================================================
add ptnr-mode rlu01.llu01.lu62bind, modename lu62bind, &
defaultmaxsession 512, defaultminconwinner 30, defaultminconloser 30, &
maxautoact 30, rcvwindow 63, sendwindow 63
=========================================================================
Add five TPNs. ==
=========================================================================
add tpn rlu01.rtp01, charmapping yes, charmapname spanish
add tpn rlu01.rtp02, charmapping yes, charmapname french
add tpn rlu01.rtp03, charmapping yes
add tpn rlu01.rtp04, charmapping yes, charmapname unitedkingdom
add tpn rlu01.rtp05, charmapping yes
=========================================================================
== Start the environment. ==
=========================================================================
start lu *
start lu *,sub ptnr-lu
start lu *,sub tpn
assume process $apc1
start lu *,sub all
status lu $apc1.*,sub all
status lu $apc2.*,sub all
exit
SNAX/XF or SNAX/CDF Example
allow all errors
timeout 200
=========================================================================
== $APC1 is the local node in this example. ==
=========================================================================
assume process $apc1