SNAX/APC Configuration and Management Manual

Trace Analysis Program
SNAX/APC Configuration and Management Manual—138787
5-4
FROM Command
To enable FILTER, at least one of these six parameters has to be specified:
LU
filters only those records concerning a specific LU, which is represented by an LU
ID.
SESSION
filters only those records associated with a session represented by a session ID.
TPI
filters only those records associated with a specific TPI represented by an TPI ID.
CONV
filters only those records concerning a specific conversation represented by a
conversation ID.
OCB
filters only those records associated with a specific opener represented by an open
ID.
RID
filters only those records associated with a specific resource ID.
To disable FILTER, simply enter the FILTER command without any parameters.
Examples
The following example only filters records for a specific LU, that is: LU #4 :
FMT> FILTER LU 4
The following example only filters records for LU #4, TPI 004C, and using session
0005.
FMT> FILTER LU 4 SESSION 5 TPI 4C
The following example disables the filter.
0005FMT> FILTER
FROM Command
Use the FROM command to designate the TRACE data file. This command can be used
to change or override the file name specified by IN at run time.
F[ROM] trace-file