SNAX/APC Configuration and Management Manual

Introduction to SCF for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
6-9
Environmental Requirements
To obtain information on the SNAX/APC syntax of object types and the commands that
apply to them, you enter the following command:
HELP SNAXAPC [ command ] [ object-type ]
Environmental Requirements
The current version of this product is compatible with the D-series operating system at
version DXX and subsequent versions.
The current version of this product is compatible with the G-series operating system at
version G06 and subsequent versions.
The Subsystem Control Point (SCP) is the required interface between SCF and the
SNAX/APC subsystem.
SNAX/APC uses an internal trace formatting facility called APCTAP, rather than the
PTrace utility commonly used by SCF implementations. APCTAP is described in
Part I, SNAX/APC Planning and Configuration
.