SNAX/APC Configuration and Management Manual

Objects for SNAX/APC

SNAX/APC Configuration and Management Manual—138787

7-5

Naming Conventions

The object name for the PROCESS object is $apc-process, and it has the following

format:

\node

is the name of the Tandem node on which the SNAX/APC process resides. This

node name is optional unless the SNAX/APC process resides on a different node

from the SCF process.

$apc-process

is the name of the PROCESS object. It is the SNAX/APC process name. The name

must begin with a dollar sign ($) followed by from 1 through 5 characters. The first

character must be alphabetic while the second through fifth characters can be either

alphabetic or numeric. If the node name associated with the process name is

included, the length of the process name is limited to a dollar sign ($) followed by

four characters.

The PROCESS object name must be unique within a Tandem system.

Examples

The following are valid object names for the PROCESS object:

$APC1

$APC01

PTNR-LU Object

The PTNR-LU object type describes a partner LU. You must pre-define the partner LU

before a local LU can initiate a session ( known as an “acquire”, as in acquiring a

session), but you do not need to make this static definition in the case of a session

request from a partner LU ( known as an “accept”, as in accepting a session). In the case

of an accept, you may add a PTNR-LU before a session starts (static definition) or just

allow SNAX/APC to add the PTNR-LU object dynamically when SNAX/APC receives

the unsolicited BIND request from a partner LU.

Naming Conventions

The object name for the PTNR-LU object is partner-lu, and it has the following

format:

[ \node. ]$apc-process

$apc-process.local-lu.partner-lu