SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-9
ADD LU Command
Object Specification
The object specification for the SNAX/APC ADD command is:
Considerations
•
The fully qualified name assigned to the created object must be unique.
•
If an attribute for a given object is not assigned a value in the ADD command, the
attribute’s default value is used. However, some attributes do not have a default
value, and the value must be explicitly assigned in the ADD command.
•
A given attribute can only appear once in a single ADD command.
•
If the LIKE syntax option is used, the attribute specification overrides the setting
derived from the LIKE object for that attribute.
•
You can not use the ADD command with PTNR-MODE objects that are normally
added dynamically by the SNAX/APC subsystem.
ADD LU Command
The ADD LU command defines a local LU to a SNAX/APC process.
ADD LU Attributes
The attribute specification for the LU object of the SNAX/APC ADD command consists
of the following attribute name and value combinations:
object-type object name representation
LU local-lu
PTNR-LU partner-lu
PTNR-MODE partner-mode
SESSION session-id
TPN tpn
ADD [ LU local-lu1 ] [ , LIKE local-lu2 ], attribute-spec
where attribute-spec is:
, SNANAME uninterpreted-lu-name
, SNAXFILENAME access-method-file name
[ , AUTOSTART { YES | NO } ]
[ , MAXSESSION number ]
[ , SNAXMAXRETRYCOUNT number ]
[ , SNAXRETRYTIMER number ]
[ , DYNAMICSUPPORT { YES | NO } ]
[ , LOCAL-LU-SYNC2-SUPPORT { NONE | SYNCPT } ]