SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-13
ADD PTNR-LU Command
ADD PTNR-LU Command
The ADD PTNR-LU command defines a partner LU to a local LU.
ADD PTNR-LU Attributes
The attribute specification for the PTNR-LU object of the SNAX/APC ADD command
consists of the following attribute name and value combinations:
LIKE partner-lu2
identifies an existing partner LU whose attribute values serve as the model for the
values of the attributes of the partner LU being created.
SNANAME uninterpreted-lu-name
specifies the name of the partner LU as it is known in the SNA network. It can be
up to 17 characters long if it is entered in the form:
[net-id.]partner-LU-name
where net-id is up to 8 characters long and partner-LU-name is up to 8
characters long.
The net-id name value is the name of the SNA network in which the partner LU
resides.
Note that the object name entered for partner-LU-name is the name by which
the partner LU is known to the Tandem system. The SNANAME, rather than the
partner LU object name, is used for building SNA requests (such as BIND).
LOCAL-LU-SECURITY-ACCEPTANCE { NONE | CONV |
ALREADYVERIFIED }
determines the values of the security support indicators (byte 23) in the BIND
request (if SNAX/APC is the primary LU) or the BIND response (if SNAX/APC is
the secondary LU). Setting this attribute to either CONV or ALREADYVERIFIED
does not cause security to be enforced; it merely enables security information to be
included in incoming attaches.
NONE specifies the local LU accepts no security information from the partner LU.
ADD [ PTNR-LU partner-lu1 ] [ , LIKE partner-lu2 ] ,
attr-spec
where attr-spec is:
, SNANAME uninterpreted-lu-name
[ , LOCAL-LU-SECURITY-ACCEPTANCE { NONE | CONV |
ALREADYVERIFIED }
]
[ , PARALLEL-SESSION-LU { YES | NO } ]
[ , PERIPHERAL-NODE { YES | NO } ]