SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-19
ADD TPN Command
holder for the session ID. Once the session has been started, you can use the INFO,
NAMES, or STATUS commands to determine the session ID that was assigned.
Examples
-> ASSUME PROCESS $APC1
-> ASSUME LU LU01
-> ADD SESSION CICSLU62.LU62BIND.*
-> ASSUME PTNR-MODE $APC1.LU01.CICSLU62.LU62BIND
-> ADD SESSION *
-> ADD SESSION $APC1.LU01.CICSLU62.LU62BIND.*
ADD TPN Command
The ADD TPN command defines a transaction program by name to a local LU.
ADD TPN Attributes
The attribute specification for the TPN object of the SNAX/APC ADD command
consists of the following attribute name and value combinations:
LIKE tpn2
identifies an existing TPN object whose attribute values serve as the model for the
values of the attributes of the TPN object being created.
CHARMAPPING { YES | NO }
specifies whether SNAX/APC performs character translation for all mapped
conversations subordinate to the target TPN.
YES indicates that character translation will be performed. NO indicates that
character translation will not be performed.
The default value is NO.
ADD [ TPN tpn1 ] [ , LIKE tpn2 ] [ , attribute-spec ]
where attribute-spec is:
[ , CHARMAPPING { YES | NO } ]
[ , CHARMAPNAME [ mapname ] ]
[ , GENERALTPREADY { YES | NO } ]
[ , REMOTEATTACH { QUEUE | REJECT } ]
[ , REMOTEATTACHTIMER number ]
[ , REPLYDELAYEDONERROR { YES | NO } ]
[ , SECURITYREQUIRED { NONE | USER } ]
[ , SESSIONCONTROL { YES | NO } ]