SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-26
ALTER PROCESS Command
Examples
-> ASSUME LU $APC1.LU01
-> ABORT
-> ALTER, SNAXFILENAME $NT21.#LUCICS, MAXSESSION 100
-> STOP LU $APC2.LU01
-> ALTER LU $APC2.LU01, MAXSESSION 100, AUTOSTART YES, &
LOCAL-LU-SYNC2-SUPPORT SYNCPT
-> ASSUME PROCESS $APC1
-> STOP LU LU03
-> ALTER LU LU03, SNAXMAXRETRYCOUNT 10, SNAXRETRYTIMER 6000
-> ASSUME LU $APC1.LU01
-> ABORT
-> ALTER,SNAXFILENAME, DYNAMICSUPPORT YES
(The last example specifies dynamic support and a dynamically-set
SNAXFILENAME.
)
ALTER PROCESS Command
The ALTER PROCESS command changes the attribute settings of the SNAX/APC
process.
ALTER PROCESS Attributes
The attribute specification for the PROCESS object of the SNAX/APC ALTER
command consists of the following attribute name and value combinations:
ALTER [ PROCESS $apc-process ] [ , attribute-spec ]
where attribute-spec is:
[ , BACKUPCPU { cpu-number | STOP } ]
[ , BACKUPDEBUG { YES | NO } ]
[ , CHARMAPFILE charactermap-file-name ]
[ , CHARMAPNAME [ mapname ] ]
[ , COLLECTOR [ collector-file-name ] ]
[ , COLLECTOR-1 [ collector-file-name-1 ] ]
[ , COLLECTOR-2 [ collector-file-name-2 ] ]
[ , COLLECTOR-3 [ collector-file-name-3 ] ]
[ , CONFIG [ configuration-file-name ] ]
[ , DEBUGONERROR { YES | NO } ]
[ , EMSSUPPRESS [ object-type ]
[ ( object-type1 [ , object-type2 ]...) ]
[ ALL ]
[ , MSG message-file-name ]
[ , LOGFILE [ log-file-name ] ]