SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-38
ASSUME Command
Examples
-> ASSUME TPN $APC1.LU01.ACCT
-> ALTER, GENERALTPREADY NO, REMOTEATTACH REJECT, &
SESSIONCONTROL NO, SECURITYREQUIRED USER
-> ASSUME LU $APC1.LU01
-> ALTER TPN ACCT, GENERALTPREADY NO, REMOTEATTACH QUEUE, &
REMOTEATTACHTIMER 43200000, SECURITYREQUIRED USER
-> ASSUME PROCESS $APC1
-> ALTER TPN LU01.ACCT001, REPLYDELAYEDONERROR YES, &
REMOTEATTACHTIMER (10:00)
-> ASSUME LU $APC1.LU01
-> ALTER TPN ACCT, CHARMAPPING YES, &
CHARMAPNAME FRENCH
-> ALTER TPN $APC1.LU01.ACCT, CHARMAPPING NO
-> ALTER TPN $APC1.LU01.ACCT, CHARMAPNAME
(The previous example has no CHARMAPNAME value indicating
standard ASCII-to-EBCDIC translation.)
ASSUME Command
The ASSUME command establishes the default object type or object name for
subsequent commands. The default object name is used when the object name is
omitted from a command or is only partially qualified. If no default object name has
been established and the object name is omitted from a command, a syntax error
message is generated.
ASSUME is a nonsensitive command.
Command Syntax
The ASSUME command has the following syntax:
ASSUME [ object-spec ]