SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC

SNAX/APC Configuration and Management Manual—138787

8-41

ASSUME TPN Command

The ASSUME TPN command sets the TPN object as the default object type for

subsequent commands, and optionally, sets the default object name.

Examples

-> ASSUME TPN

-> ASSUME TPN LU01.ACCT

DELETE Command

The DELETE command removes objects that were added with the ADD command.

However, the specified object can only be deleted when it is in the STOPPED state and

all of its subordinate objects have been removed.

DELETE is a sensitive command.

Command Syntax

The DELETE command has the following syntax:

Object Specification

The object specification for the SNAX/APC DELETE command is:

Considerations

•

The SUB ONLY parameter cannot be used with the DELETE PTNR-MODE

command.

•

The CONV, SESSION, and TPI objects cannot be deleted.

•

If you issue the DELETE LU * command (using the the wild-card character), all

subordinate objects except the TPN object named %06F1% and the PTNR-MODE

object named SNASCVMG are deleted.

DELETE LU Command

The DELETE LU command removes a local LU from a SNAX/APC process.

DELETE [ object-spec ] [ , SEL [ NOT ] summary-state ]

[ , SUB [ subtype ] ]

object-type object name representation

LU local-lu

PTNR-LU partner-lu

PTNR-MODE partner-mode

TPN tpn