SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-47
INFO LU Command
SNAX FileName
displays the file name of the Tandem access method that the local LU uses to
exchange information with the SNA network.
Max Sess
displays the maximum number of sessions that the local LU can have. If the value
of Max Sess is 1, the local LU is treated as a single-session LU. If the value of Max
Sess is greater than 1, the local LU is treated as a parallel-session LU.
Auto Start
YES indicates that the local LU is started automatically during the SNAX/APC
process initialization. When SNAX/APC is started and a non-empty configuration
file is specified, all LUs referenced in the file and listed as AUTOSTART will be
automatically started.
NO indicates that the local LU is not started automatically during the SNAX/APC
process initialization, and the START LU command must be explicitly issued.
INFO LU Detailed Display
This example shows the request for detailed information about the LU named LU01:
-> INFO LU $APC1.LU01
The following display is returned in response to this request:
SNAName
displays the name of the local LU as it is known in the SNA network. The
SNAName is used for building SNA requests (such as the session activation BIND
request).
SNAXFileName
displays the file name of the Tandem access method that the local LU uses to
exchange information with the SNA network.
SNAX/APC DETAILED INFO LU: $APC1.LU01
*SNAName ..................... LU01
*SNAXFileName ................ \TSNA.$SNA1.#LU101
*MaxSession .................. 1024
*AutoStart ................... YES
*SNAXMaxRetryCount ........... 20
SNAXRetryCount .............. 1
*SNAXRetryTimer .............. 00:01:30.00
*DynamicSupport .............. NO
*LOCAL-LU-SYNC2-SUPPORT ...... NONE
Note. Attributes marked with an asterisk (
*
) can be altered using the ALTER command.