SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-59
INFO PTNR-MODE Command
parameter of the INITIALIZE_SESSION_LIMIT CNOS verb (which is issued as a
result of a START PTNR-MODE command).
The sum of the DEFAULTMINCONWINNER attribute and the
DEFAULTMINCONLOSER attribute should be less than or equal to the value of the
DEFAULTMAXSESSION attribute.
INFO PTNR-MODE Detailed Display
This example shows the request for detailed information about the target PTNR-MODE
object:
-> INFO PTNR-MODE $APC1.LU01.CICSLU62.LU62BIND
The following display is returned in response to this request:
ModeName
is the mode name used for building SNA requests (such as the session activation
BIND request). It is also used as the AL-MODENAME parameter of the
ALLOCATE verb or the MC-AL-MODENAME parameter of the MC_ALLOCATE
verb.
All parallel session partner LUs have the PTNR-MODE named SNASVCMG.
SNAX/APC DETAILED INFO PTNR-MODE:
$APC1.LU01.CICSLU62.LU62BIND
*ModeName ............................ LU62BIND
*DefaultMaxSession ................... 30
*DefaultMinConWinner ................. 10
*DefaultMinConLoser .................. 10
*MaxAutoAct .......................... 5
*RcvWindow ........................... 7
*SendWindow .......................... 7
ActvConWinner ....................... 0
ActvConLoser ........................ 1
ActvSessCnt ......................... 1
TerminateCount ...................... 0
*MaxSession .......................... 30
*MinConWinner ........................ 10
*MinConLoser ......................... 10
*Responsible ......................... SOURCE
DrainSource ......................... YES
DrainTarget ......................... YES
*DefaultMaxInRUSize .................. 4096
*DefaultMaxOutRUSize ................. 4096
CurrentMaxInRUSize .................. 4096
CurrentMaxOutRUSize ................. 4096
Note. Attributes marked with an asterisk (*) can be altered using the ALTER command.