SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-61
INFO PTNR-MODE Command
ActvSessCnt
displays the number of currently active sessions.
TerminateCount
displays the number of sessions that need to be terminated.
MaxSession
displays the maximum number of sessions allowed between a local LU and a partner
LU for a specified mode name. If the value of MaxSession is 1, the local LU is
treated as a single-session LU (an LU that does not support parallel sessions). If the
value of MaxSession is greater than 1, the local LU is treated as a parallel-session
LU.
MinConWinner
displays the minimum number of contention-winner sessions that the partner mode
has. The value was established by the last CNOS command.
MinConLoser
displays the minimum number of contention-loser sessions the partner mode has.
The value was established by the last CNOS command.
Responsible
displays the LU designated to deactivates sessions when a change decreases the
session limit or the maximum number of contention-winner sessions for the source
or target LU. The value was established by the last CNOS command.
SOURCE specifies that the local LU is responsible, and TARGET specifies that the
remote LU is responsible.
DrainSource
displays whether or not the local LU will satisfy any pending allocation requests
before terminating a session. This value was established by the last CNOS
command. YES indicates that pending allocation requests will be satisfied. NO
indicates that the session will be terminated immediately without satisfying pending
allocation requests.
DrainTarget
displays whether or not the partner LU will satisfy any pending allocation requests
before terminating a session. This value was established by the last CNOS
command. YES indicates that pending allocation requests will be satisfied. NO
indicates that the session will be terminated immediately without satisfying pending
allocation requests.