SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-62
INFO SESSION Command
DefaultMaxInRUSize
returns the maximum size of normal flow request units (RUs) that the local LU can
receive over sessions started with this mode.
DefaultMaxOutRUSize
returns the maximum size of normal flow request units (RUs) that the local LU can
send over sessions started with this mode.
CurrentMaxInRUSize
returns the current maximum size of normal flow request units (RUs) that the local
LU receives on the session. This value is set after the local LU has opened the
underlying access method. This value is used to construct BIND images for local
LU-initated sessions.
CurrentMaxOutRUSize
returns the current maximum size of normal flow request units (RUs) that the local
LU sends on the session. This value is set after the local LU has opened the
underlying access method. This value is used to construct BIND images for local
LU-initated sessions.
INFO SESSION Command
The INFO SESSION command displays the current attribute settings of the specified
session.
INFO SESSION Nondetailed Display
This example shows the request for nondetailed information about the current sessions
using the LU named LUP:
-> INFO SESSION $AP01.LUP.*
The following display is returned in response to this request:
SESSION Name
displays the session name.
SNAX/APC INFO SESSION:
SESSION Name FQPCID Type
-------------------------------------------------------------
-
$AP01.LUP.LUS.SNASVCMG.0001 %H54323141 0000000005 Primary
$AP01.LUP.LUS.SNASVCMG.0001 %H54323141 0000000001
Secondary
$AP01.LUP.LUS.LUPS.0005 %H54323141 0000000049 Primary