SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-69
LISTOPENS Command
CharMap Name
indicates the translation table which SNAX/APC uses to perform character
translation for all mapped conversations subordinate to the target TPN.
CharMap Note
returns a description of the character translation table. It is obtained from the
character map file and is present only if the default character map file for the
SNAX/APC process is not the standard ASCII-to-EBCDIC translation.
SecurityRequired
NONE specifies the transaction program requires no security checking before
granting access privileges. Any incoming attach that specifies the transaction
program can access the transaction program.
USER specifies an attach must supply a valid user ID and password pair or a valid
user ID and the already-verified indicator before it can start a conversation with the
transaction program. If the attach includes a user ID and the already-verified
indicator, SNAX/APC verifies that the user ID exists locally before granting access
to the transaction program.
SessionControl
YES indicates that the transaction program is authorized to issue the
ACTIVATE-SESSION and DEACTIVATE-SESSION session control verbs.
NO indicates that the transaction program is not authorized to issue the session
control verbs.
RemoteAttachTimer
specifies the amount of time in milliseconds that SNAX/APC will wait for a remote
TP-READY to arrive to satisfy an ATTACH
ReplyDelayedOnError
YES indicates that SNAX/APC will not reply to a waiting TP-READY verb until the
LU is started or the maximum number of retries has been attempted, whichever
comes first.
NO indicates SNAX/APC replies to a waiting TP-READY verb immediately after
the first attempt is made to open the SNAX access method.
LISTOPENS Command
The LISTOPENS command displays a list of all file system OPEN calls that apply to the
SNAX/APC process.
LISTOPENS is a nonsensitive command.