SNAX/APC Configuration and Management Manual

SCF Commands for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
8-94
STATUS SESSION Command
Between Brackets
In Brackets
FSM-CHAIN-RCV
indicates the received chain states. The possible values are:
Between Chains
In Chains
Negative Response Sent
Pending Response
Pending Send Reply
FSM-CHAIN-SEND
indicates the sending chain states. The possible values are:
Between Chains
In Chains
Negative Response Received
Pending Response
Pending Receive Reply
FSM-CONVERSATION
indicates the conversation status. The possible values are:
Reset
Send
Receive
Receive Confirm
Receive Confirm Send
Receive Confirm Deallocate
Prepare to Receive Defer
Deallocate Defer
Pending Deallocate
End Conversation
FSM-ERROR-OR-FAILURE
indicates errors or failures reported by other SNA layers. The possible values are:
No Requests (initial state)
Received Error
Conversation Failure Protocol Error
Conversation Failure Session Outage Notification
Allocate Failure Retry
Allocate Failure No Retry
Synchronization Level Not Supported
FSM-PAC-RQ-RCV
indicates whether the LU can send a pacing response for receive pacing. The
possible values are: