SNAX/APC Configuration and Management Manual

SCF Command Syntax Summary for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
B-6
ALTER TPN Command
ALTER TPN Command
The ALTER TPN command modifies the values of the attribute settings of an existing
object.
ASSUME Command
The ASSUME command sets up the default object type or object name for subsequent
commands. The default object name is used when the object name is omitted from a
command or is only partially qualified. If no default object name has been established
and the object name is omitted from a command, a syntax error message is generated
ASSUME CONV Command
ASSUME LU Command
ASSUME PROCESS Command
ASSUME PTNR-LU Command
ASSUME PTNR-MODE Command
ALTER [ TPN $apc-process.local-lu.tpn1 ]
[, LIKE tpn2 ] [ , attribute-spec ]
where attribute-spec is:
[ , CHARMAPPING { YES | NO } ]
[ , CHARMAPNAME [ mapname ] ]
[ , GENERALTPREADY { YES | NO } ]
[ , REMOTEATTACH { QUEUE | REJECT } ]
[ , REMOTEATTACHTIMER number ]
[ , REPLYDELAYEDONERROR { YES | NO } ]
[ , SECURITYREQUIRED { NONE | USER } ]
[ , SESSIONCONTROL { YES | NO } ]]
ASSUME [ CONV $apc-process.local-lu.tpn.tpi-id.conv-id ]
ASSUME [ LU $apc-process.local-lu ]
ASSUME [ PROCESS $apc-process ]
ASSUME [ PTNR-LU $apc-process.local-lu.partner-lu ]
ASSUME [ PTNR-MODE $apc-process.local-lu.ptnr-lu.ptnr-mode ]