SNAX/APC Configuration and Management Manual

SCF Command Syntax Summary for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
B-13
STOP PTNR-MODE Command
STOP PTNR-MODE Command
STOP SESSION Command
STOP TPI Command
STOP TPN Command
TRACE Command
The TRACE command starts, stops, or changes the trace selection of the target object.
TRACE LU Command
STOP [ PTNR-MODE $apc-process.local-lu.ptnr-lu.ptnr-mode ]
[, attribute-spec ]
where attribute-spec is:
[ , DRAINSOURCE { YES | NO } ]
[ , DRAINTARGET { YES | NO } ]
[ , { NORMAL | FORCE } ]
[ , RESPONSIBLE { SOURCE | TARGET } ]
[ , SEL [ NOT ] summary-state ]
[ , SUB [ subtype ] ]
STOP [ SESSION $apc-proc.local-lu.ptnr-lu.ptnr-mode.sessid ]
[ , { NORMAL | FORCE } ]
STOP [ TPI $apc-process.local-lu.tpn.tpi-id ]
[, SEL [ NOT ] summary-state ]
[, SUB [ { subtype | ALL | NONE } ] ]
STOP [ TPN $apc-process.local-lu.tpn ]
[, SEL [ NOT ] summary-state ]
[, SUB [ subtype ] ]
TRACE [ LU $apc-proc.local-lu ]
{ [ , STOP ] | [ , TO file-name [, attribute-spec ] ] }
where, if TO is specified, attribute-spec is none or more of the following:
[ , PAGES number ]
[ , RECSIZE number ]
[ , SELECT { ALL | [(} opt [ ,opt ... ] [)] }
[ , { WRAP | NOWRAP } ]