SNAX/APC Configuration and Management Manual

SCF Error Messages for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
C-5
Error 00007
The error is caused by an ABORT or STOP PTNR-MODE command.
Recommended Action. None. This message is a warning that the PTNR-MODE object
has aborted.
Error 00007
Probable Cause. The ALTER and DELETE commands cannot act upon either the
default PTNR-MODE object, SNASVCMG, or the default TPN object, %06F1%. The
command was therefore rejected by SNAX/APC.
Recommended Action. Do not use the ALTER or DELETE command with the default
PTNR-MODE or TPN objects (SNASVCMG and %06F1%, respectively).
Error 00008
Probable Cause. An ALTER PTNR-MODE command was issued for a single-session
LU when it was in the STARTED state.
Recommended Action. Do not use the ALTER PTNR-MODE command for a single-
session LU when it is in the STARTED state.
Error 00009
Probable Cause. The CNOS command was processed as negotiated by the partner LU.
The equivalent return code, as defined in the IBM Transaction Programmer’s Reference
Manual for LU 6.2, is OK _AS_NEGOTIATED.
This error is displayed when either the START, ALTER, STOP, or ABORT PTNR-
MODE command has been processed successfully with parameters negotiated by the
partner LU.
Recommended Action. None. This message is a warning that the attributes of the
PTNR-MODE have been changed according to the negotiated values, and are different
from the attribute values specified in the command.
Error 00010
Probable Cause. A CNOS operation initiated by the partner LU was being processed
when an ABORT, STOP, ALTER, or START command was issued, and the CNOS
SNAXAPC 00007 This command cannot act upon a default object.
SNAXAPC 00008 This command cannot act upon a single-session
LU.
SNAXAPC 00009 The CNOS command was processed as negotiated.
SNAXAPC 00010 The command was rejected because a command race
occurred.