SNAX/APC Configuration and Management Manual

SCF Error Messages for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
C-8
Error 00018
Recommended Action. Use the INFO command to verify the target PTNR-MODE
object’s mode name, and use the ALTER PTNR-MODE command to change it.
Error 00018
Probable Cause. A command attempting to delete a default object was rejected. The
default object was probably either the default PTNR-MODE object, SNASVCMG, or
the default CNOS TPN, %06F1.
Recommended Action. Do not attempt to delete a default object.
Error 00019
Probable Cause. The command was rejected because of its attempt to stop or abort the
default PTNR-MODE object, SNASVCMG, while other related PTNR-MODE objects
were not in the STOPPED state.
Recommended Action. Abort or stop all of the related PTNR-MODE objects before
attempting to stop or abort the default PTNR-MODE object, SNASVCMG.
Error 00020
Probable Cause. This is a generic parameter error, caused by an undefined error.
Recommended Action. You need to seek additional help. Follow the procedures
described at the beginning of this appendix for collecting relevant information and
contacting the appropriate support personnel.
Error 00021
Probable Cause. This error was probably caused by a START or ALTER PTNR-MODE
command, when the sum of the MINCONWINNER and MINCONLOSER attributes
specifies a number greater than the value of the MAXSESSION attribute. The
equivalent return code defined in the IBM Transaction Programmer’s Reference Manual
for LU 6.2 is REQUEST_EXCEEDS_MAX_ALLOWED.
Recommended Action. Make sure that the value of MAXSESSION is greater than the
sum of values of MINCONWINNER and MINCONLOSER and reinitiate the command.
SNAXAPC 00018 The default object cannot be deleted.
SNAXAPC 00019 The related PTNR-MODEs are not STOPPED.
SNAXAPC 00020 Parameter error.
SNAXAPC 00021 The request exceeds the maximum session limit
allowed.