Manualshelf

SNAX/APC Configuration and Management Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series
321322323324325326327328329330
SCF Error Messages for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
C-9
Error 00022
Error 00022
Probable Cause. A resource failure occurred during the processing of a CNOS-related
command. The equivalent return code, as defined in the IBM Transaction
Programmer’s Reference Manual for LU 6.2 is RESOURCE_FAILURE_NO_RETRY.
This error was probably caused by an ABORT, STOP, ALTER, or START PTNR-
MODE command.
The CNOS-related command did not execute successfully because of a failure that
caused the Control-Operator conversation to be prematurely deallocated. For example,
the session being used for the Control-Operator conversation was deactivated because of
one of the following reasons:
•
A session protocol error occurred
•
A session outage from which the control operator component of the LU could not
recover occurred
•
The conversation was deallocated because of a protocol error between the control
operator components of the LUs
•
The session cannot be established
Recommended Action. The request should not be retried until the cause of the resource
failure is cleared. Check the EMS event log for help in determining the cause of the
resource failure.
Error 00023
Probable Cause. An ABORT or STOP command was issued to request draining on the
local LU, and the request was denied by the partner LU.
The equivalent return code defined in the IBM Transaction Programmer’s Reference
Manual for LU 6.2 is LU_MODE_SESSION_LIMIT_CLOSED.
Recommended Action. None.
Error 00024
Probable Cause. This error indicates that a START PTNR-MODE command has been
issued for an already-initialized PTNR-MODE object, and the session limit is already
greater than 0. The local and remote LUs’ CNOS parameters are not changed.
The equivalent return code defined in the IBM Transaction Programmer’s Reference
Manual for LU 6.2 is LU_MODE_SESSION_LIMIT_NOT_ZERO.
SNAXAPC 00022 A resource failure occurred.
SNAXAPC 00023 The session limit cannot be raised above 0.
SNAXAPC 00024 The session limit is already greater than 0.