SNAX/APC Configuration and Management Manual

SCF Error Messages for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
C-10
Error 00025
Recommended Action. Issue the ALTER PTNR-MODE command instead.
Error 00025
Probable Cause. An ALTER PTNR-MODE command attempted to change the PTNR-
MODE object’s session limit, and was rejected because the PTNR-MODE object was in
the STOPPED state and the session limit is 0.
The equivalent return code defined in the IBM Transaction Programmer’s Reference
Manual for LU 6.2 is LU_MODE_SESSION_LIMIT_ZERO.
Recommended Action. Issue a START PTNR-MODE command instead.
Error 00026
Probable Cause. A START PTNR-MODE command was rejected because it attempted
to start related PTNR-MODE objects before the default PTNR-MODE object,
SNASVCMG, was started.
Recommended Action. Start the PTNR-MODE object SNASVCMG before attempting
to start its related PTNR-MODE objects.
Error 00027
Probable Cause. This is a SNAX/APC internal error.
Recommended Action. You need to seek additional help. Follow the procedures
described at the beginning of this appendix for collecting relevant information and
contacting the appropriate support personnel.
Error 00028
Probable Cause. This error was caused by an attempt to delete an LU, PTNR-LU,
PTNR-MODE, or TPN object while one or more of its subordinates existed.
Recommended Action. Specify the SUB parameter with the command, or make sure all
sessions are aborted before issuing the command.
SNAXAPC 00025 The session limit has not been initialized -
it is still set to 0.
SNAXAPC 00026 The PTNR-MODE SNASVCMG was not started.
SNAXAPC 00027 Internal Error: SNASVCMG parameter error.
SNAXAPC 00028 Subordinate objects were not stopped.