SNAX/APC Configuration and Management Manual

Comparison of LU 6.2 Control Operator Verbs and
SNAX/APC
SNAX/APC Configuration and Management Manual—138787
D-3
RETURN_CODE (Command Return)
DEFINE_MODE ADD PTNR-MODE
FULLY_QUALIFIED_LU_NAME (Superior partner-lu )
MODE_NAME MODENAME
SEND_MAX_RU_SIZE_LOWER_BOUND MAXOUTRUSIZE (APC START
parameter)
SEND_MAX_RU_SIZE_UPPER_BOUND MAXOUTRUSIZE (APC START
parameter)
RECEIVE_MAX_RU_SIZE_LOWER_BOUND
MAXINRUSIZE (APC START
parameter)
RECEIVE_MAX_RU_SIZE_UPPER_BOUND
MAXINRUSIZE (APC START
parameter)
SINGLE_SESSION_REINITIATION (Always PLU_or_SLU)
SESSION_LEVEL_CRYTOGRAPHY (Not implemented)
CONWINNER_AUTO_ACTIVATE_LIMIT MAXAUTOACT
PREFERRED_RECEIVE_RU_SIZE (Not implemented)
PREFERRED_SEND_RU_SIZE (Not implemented)
SESSION_DEACTIVATED_TP_NAME (Not implemented)
LOCAL_MAX_SESSION_LIMIT (Not implemented)
RETURN_CODE (Command Return)
DEFINE_REMOTE_LU ADD PTNR-LU
FULLY_QUALIFIED_LU_NAME (partner-lu)
LOCALLY_KNOWN_LU_NAME (partner-lu)
UNINTERPRETED_LU_NAME SNANAME
INITIATE_TYPE (Always INITIATE_ONLY)
PARALLEL_SESSION_SUPPORT PARALLEL-SESSION-LU
CNOS_SUPPORT PARALLEL-SESSION-LU
LU_LU_PASSWORD (Not implemented)
SECURITY_ACCEPTANCE (Not implemented)
RETURN_CODE (Command Return)
DEFINE_TP ADD TPN
TP_NAME (tpn)
STATUS (Not implemented)
Table D-3. Definition Verbs Versus SNAX/APC SCF Commands and
Attributes (page 2 of 5)
Definition Verbs and Parameters SCF Commands and Attributes