SNAX/APC Configuration and Management Manual

Event Management
SNAX/APC Configuration and Management Manual—138787
E-37
25: ZAPC-EVT-CNOS-CONV-FAIL
ZAPC-VAL-CONV-FAILED-AT-RAW
is returned if the CNOS conversation failed at the Receive_and_Wait verb.
ZAPC-VAL-CONV-FAILED-AT-SD
is returned if the CNOS conversation failed at the Send_Data verb.
ZAPC-TKN-RC-RETN
identifies the REP-RETURN-CODE of the failed CNOS conversation verb.
ZAPC-TKN-RC-RETN-DETL
identifies the REP-RETURN-CODE-DETAIL of the failed CNOS conversation
verb.
Cause. The CNOS conversation failed at the specified conversation verb.
Effect. If the local LU is the source LU, the associated DSM request is rejected. If the
local LU is the target LU, this serves as an informational event; in this case, the remote
LU should report a similar event. Whether the LU is the source Lu or the target LU, no
session limit is changed.
Recovery. If the local LU is the target LU, this is an informational message only; no
corrective action is required. If the local LU is the source LU, retry the DSM request at
the local LU, or reinitiate the CNOS operation at the remote LU.