SNAX/APC Configuration and Management Manual

Planning for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
2-8
VTAM Definition Parameters
The following mode-entry source is acceptable for SNAX/APC to CICS. Default values
are assumed for this entry.
LOGMODE TABLE:
MODEENT LOGMODE=cicslu62 MODEEND
The mode name (cicslu62) is the mode name specified in the SNAX/APC configuration
(MODE) and in the CICS terminal control table (MODNAME).
Default values are:
LOGMODE=blanks, COMPROT=0, COS=blanks, ENCR=0,
FMPROF=0, PRIPROT=0, PSERVIC=0, PSENDPAC=0,
RUSIZES=value, (no limit on size)
SECPROT=0, SRCVPAC=0, SSNDPAC=0, TSPROF=0,
TYPE=1 (non-negotiable)
Default values for all parameters except LOGMODE, PRIPROT, and SECPROT are
acceptable because they are overridden by CICS, NCP, and SNAX/APC. PRIPROT and
SECPROT should contain the value B0, which is required for LU 6.2. The RUSIZE
parameter value should be the same as the defined size in SNAX/APC for the
corresponding PTNR-MODE object.
This mode entry should be entered into the logon mode table or the default logon
mode table.
VTAM/NCP DEFINITIONS:
Name Macro Parameter Notes
CICS1 APPL [ACBNAME=CICS], 1
[AUTH=([VPACE|NVPACE]), 2
[VPACING=n|0], 3
:
puname PU ADDR=xx, 4
IRETRY=NO,
MAXDATA=nnnn,
ISTATUS=INACTIVE,
MAXOUT=7,
PASSLIM=7,
PUTYPE=2,
RETRIES=(,1,4),
MODETAB=modetabl, 5
DLOGMOD=M32782, 6
:
luname LU LOCADDR=nn,
PACING=0, 7
VPACING=0, 7
: