SNAX/APC Configuration and Management Manual

Configuring Network Resources for SNAX/APC
SNAX/APC Configuration and Management Manual—138787
4-16
Configuring a Local TP Name
The ADD TPN command defines a TP name to a local LU. The attribute specification
for the TPN object of the SNAX/APC ADD command consists of the following attribute
name and value combinations:
TPN tpn
identifies the name of the TPN.
LIKE tpn2
identifies an existing TPN object whose attribute values serve as the model for the
values of the attributes of the TPN object being created.
CHARMAPPING { YES | NO }
specifies whether SNAX/APC performs character translation for all mapped
conversations subordinate to the target TPN.
YES indicates that character translation will be performed. NO indicates that
character translation will not be performed.
The default value is NO.
CHARMAPNAME [ mapname ]
specifies the translation table which SNAX/APC will use to perform character
translation for all mapped conversations subordinate to the target TPN. If this
attribute is omitted, the character map name specified on process startup or through
APCRUN is used. The CHARMAPNAME attribute can be present even if character
translation is not enabled. In this case, the CHARMAPNAME value will be used
only when character translation is subsequently enabled.
If the mapname value is omitted, the Tandem standard ASCII-to-EBCDIC
translation table is used.
GENERALTPREADY { YES | NO }
YES specifies that the transaction program supports the general TP-READY feature.
ADD [ TPN tpn1 ] [ , LIKE tpn2 ] [ , attribute-spec ]
where attribute-spec is:
[ , CHARMAPPING { YES | NO } ]
[ , CHARMAPNAME [ mapname ] ]
[ , GENERALTPREADY { YES | NO } ]
[ , REMOTEATTACH { QUEUE | REJECT } ]
[ , REMOTEATTACHTIMER number ]
[ , REPLYDELAYEDONERROR { YES | NO } ]
[ , SECURITYREQUIRED { NONE | USER } ]
[ , SESSIONCONTROL { YES | NO } ]