SNAX/APC Management Programming Manual

TRACE Command
Commands and Responses
111813 Tandem Computers Incorporated 5–113
ZCOM-TKN-SEL-SUMSTATE
indicates that the command applies only to objects in a specific summary state.
Refer to Section 3, “Elements of SPI Messages for SNAX/APC,” for further
information on summary states.
(ZSPI-TKN-)MAXRESP, CONTEXT, and ALLOW-TYPE
are standard SPI tokens described in the SPI Programming Manual.
Tokens in Response Buffer
ZSPI-TKN-DATALIST
is a standard SPI data list, as described in the SPI Programming Manual. The list
ends with the token ZSPI-TKN-ENDLIST.
ZCOM-TKN-OBJNAME
is a standard data communications token that identifies the object name and the
SNAX/APC process name. SNAX/APC object names have the format
$ snax/apc-process-name . object-name . This token is always present in the
response buffer. Refer to Section 3, “Elements of SPI Messages for SNAX/APC,”
for further information on object names.
ZCOM-TKN-OBJTYPE
is a standard data communications token that indicates the object type. For
ZCOM-CMD-TRACE, the valid object types are PROC and LU.
ZSPI-TKN-RETCODE
indicates whether the command was successful and, if not, the reason for failure.
ZSPI-TKN-ERRLIST
is a standard SPI error list, as described in the SPI Programming Manual. The list
ends with the token ZSPI-TKN-ENDLIST.
ZSPI-TKN-CONTEXT
is the standard SPI context token discussed in the SPI Programming Manual.
Operational Notes
The ZCOM-TKN-SUB token is not allowed for the ZCOM-CMD-TRACE
command.
The ZCOM-CMD-TRACE command for the PROC object is intended for
debugging internal SNAX/APC problems.