SNAX/APC Management Programming Manual

24: ZAPC-ERR-SESS-LIM-NOT-ZERO
Error Numbers and Error Lists
111813 Tandem Computers Incorporated A–29
24: ZAPC-ERR-SESS-LIM-NOT-ZERO
The session limit is already greater than 0.
ZSPI–TKN–ERRLIST token–type ZSPI–TYP–LIST.
ZSPI–TKN–ERROR token–type ZSPI–TYP–ERROR.
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-STRING
ZSPI–TKN–ENDLIST token–type ZSPI–TYP–SSCTL.
ZSPI–TKN–ERROR
is the standard SPI error token, as described in the SPI Programming Manual. Its
value consists of the subsystem ID and the error number found in the ZAPC–ERR–
SESS–LIM–NOT–ZERO token. ZSPI–TKN–ERROR is always present in the error
list.
ZCOM-TKN-OBJNAME
is the first object name provided with the command on which the error occurred.
This token is always present in the error list, and is described in Section 4,
“Common Definitions.”
ZCOM-TKN-OBJTYPE
is the object type provided with the command on which the error occurred. This
token is always present in the error list, and is described in Section 4, “Common
Definitions.”
Cause
This error indicates that a START PTNR-MODE command has been issued for an
already-initialized PTNR-MODE object, and the session limit is already greater than 0.
The local and remote session limit's parameters are not changed.
The equivalent RETURN_CODE value defined in the IBM Transaction Programmer's
Reference Manual for LU 6.2 is LU_MODE_SESSION_LIMIT_NOT_ZERO.
Effect
The session limit cannot be raised above 0.
Recovery
Issue the ALTER PTNR-MODE command instead.