SNAX/APC Management Programming Manual

37: ZAPC-ERR-TKN-INV-IN-SUMSTATE
Error Numbers and Error Lists
A–42 111813 Tandem Computers Incorporated
37: ZAPC-ERR-TKN-INV-IN-SUMSTATE
The parent object was not started.
ZSPI–TKN–ERRLIST token–type ZSPI–TYP–LIST.
ZSPI–TKN–ERROR token–type ZSPI–TYP–ERROR.
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-STRING
ZSPI–TKN–ENDLIST token–type ZSPI–TYP–SSCTL.
ZSPI–TKN–ERROR
is the standard SPI error token, as described in the SPI Programming Manual. Its
value consists of the subsystem ID and the error number found in the ZAPC–ERR–
TKN–INV–IN–SUMSTATE literal. ZSPI-TKN-ERROR is always present in the
error list.
ZCOM-TKN-OBJNAME
is the first object name provided with the command on which the error occurred.
This token is always present in the error list, and is described in Section 4,
“Common Definitions.”
ZCOM-TKN-OBJTYPE
is the object type provided with the command on which the error occurred. This
token is always present in the error list, and is described in Section 4, “Common
Definitions.”
Cause
An attribute specified with the ALTER PTNR-MODE command could not be changed
because the PTNR-MODE object was not in a valid summary state.
Effect
The ALTER PTNR-MODE command fails.
Recovery
Make sure that the PTNR-MODE object is in the proper summary state for the
attribute you are altering before you issue an ALTER PTNR-MODE command.