SNAX/APC Management Programming Manual

39: ZAPC-ERR-CONFIG-IS-BAD
Error Numbers and Error Lists
A–44 111813 Tandem Computers Incorporated
39: ZAPC-ERR-CONFIG-IS-BAD
The configuration file is not accessible.
ZSPI–TKN–ERRLIST token–type ZSPI–TYP–LIST.
ZSPI–TKN–ERROR token–type ZSPI–TYP–ERROR.
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-STRING
ZSPI–TKN–ENDLIST token–type ZSPI–TYP–SSCTL.
ZSPI–TKN–ERROR
is the standard SPI error token, as described in the SPI Programming Manual. Its
value consists of the subsystem ID and the error number found in the ZAPC–ERR–
CONFIG-IS-BAD literal. ZSPI–TKN–ERROR is always present in the error list.
ZCOM-TKN-OBJNAME
is the first object name provided with the command on which the error occurred.
This token is always present in the error list, and is described in Section 4,
“Common Definitions.”
ZCOM-TKN-OBJTYPE
is the object type provided with the command on which the error occurred. This
token is always present in the error list, and is described in Section 4, “Common
Definitions.”
Cause
The configuration file is not accessible and the automatic switching has also failed.
Effect
You cannot enter sensitive commands until the situation is corrected.
Recovery
Use EMS (or your log file) to determine the course of events. Find an accessible disk
volume and use the CONFIG attribute of the ALTER PROCESS command to create a
new configuration file. Retry the command after the disk failure has been remedied.