SNAX/APC Management Programming Manual

ZCOM Object Types
Common Definitions
4–8 111813 Tandem Computers Incorporated
ZCOM Object Types The SNAX/APC subsystem uses the following ZCOM object types. For more
information about these object types, refer to Section 3, “Elements of SPI Messages for
SNAX/APC.”
ZCOM-OBJ-CONVERSATION indicates a CONVERSATION object.
ZCOM-OBJ-LU indicates an LU object.
ZCOM-OBJ-NULL indicates that the object type is irrelevant or that
the command refers to a set of objects.
ZCOM-OBJ-PROC indicates a PROC object.
ZCOM-OBJ-PTNR-LU indicates a PTNR-LU object.
ZCOM-OBJ-PTNR-MODE indicates a PTNR-MODE object.
ZCOM-OBJ-SESS indicates a SESS object.
ZCOM-OBJ-TPN indicates a TPN object.
ZCOM-OBJ-TPI indicates a TPI object.
ZCOM Values SNAX/APC uses the following ZCOM token values. The summary states are
described in Section 3, “Elements of SPI Messages for SNAX/APC.”
ZCOM-VAL-SECUR-SUPP-ALL
is returned in the ZCOM-TKN-GETVSN-SECUR-SUPP response token in the
response to the GETVERSION command to indicate that all levels of security are
supported.
ZCOM-VAL-SUB-ALL
indicates that the target objects include the specified object and all subordinate
objects.
ZCOM-VAL-SUB-NONE
indicates that the target objects include the specified object only; no subordinate
objects are included.
ZCOM-VAL-SUB- object-type
indicates that the target objects include only the objects of the indicated object type
that are subordinate to the specified object.
ZCOM-VAL-SUB-ONLY
indicates that the target objects include only the objects subordinate to the
specified object.
ZCOM-VAL-SUMSTATE-STARTED
indicates the STARTED summary state.