SNAX/APC Management Programming Manual

ZAPC-TKN-RESOURCE-ID
Common Definitions
111813 Tandem Computers Incorporated 4–37
The REPLY-DELAYED-ON-ERR token has the token type ZSPI-TYP-BOOLEAN.
The programmatic commands that use this token are ZCOM-CMD-ADD, ZCOM-
CMD-ALTER, and ZCOM-CMD-INFO. The valid object type for this token is
TPN.
ZAPC-TKN-RESPONSIBLE
specifies the LU that is responsible for selecting and deactivating sessions, as a
result of a change that decreases the session limit or the maximum number of
contention-winner sessions for the source or target LU. This value is used as the
RESPONSIBLE parameter of the CHANGE_SESSION_LIMIT CNOS and
RESET_SESSION_LIMIT verbs.
The RESPONSIBLE token has the token type ZSPI-TYP-ENUM. The
programmatic commands that use this token include ZCOM-CMD-ALTER,
ZCOM-CMD-INFO, and ZCOM-CMD-STOP. The valid object type for this token
is PTNR-MODE.
The following enumerated values are valid for this token:
ZAPC-VAL-RESPONSIBLE-SOURCE
specifies that the source LU is responsible for selecting and deactivating
sessions.
ZAPC-VAL-RESPONSIBLE-TARGET
specifies that the target LU is responsible for selecting and deactivating
sessions.
The RESPONSIBLE token cannot be specified with the ALTER PTNR-MODE
command unless the PTNR-MODE object is in the STARTED state. Attempts to
do so will cause the command to be rejected with the error token ZAPC-ERR-
TKN-INV-IN-SUMSTATE.
The default value for this token is ZAPC-VAL-RESPONSIBLE-SOURCE. This
token is always returned in the ZCOM-CMD-INFO response buffer.
ZAPC-TKN-RESOURCE-ID
specifies the resources within SNAX/APC for which this conversation’s inter-
process communications (IPC) messages are intended.
The RESOURCE-ID token has the token type ZSPI-TYP-STRING, and is six
characters long. The programmatic command that uses this token is ZCOM-CMD-
INFO. The valid object types for this token are CONVERSATION and TPI.
When used with the CONVERSATION object, the RESOURCE-ID token may not
be returned in the ZCOM-CMD-INFO response buffer if CONVERSATION is in
the STARTING state. When used with the TPI object, this token may not be
returned in the ZCOM-CMD-INFO response buffer if TPI is in the STARTING
state and the value of the ZAPC-TKN-TPI-ORIGIN token is ZAPC-VAL-TPI-
ORIGIN-REMOTE.