SNAX/APN Application Programming Manual

Logic Flows and Internal Formats When Using
SNALU
SNAX/APN Application Programming Manual—420111-001
C-10
SLU Accept Mode: Session Initiation
C07CDT .CDD
Application #2
SNAX/APN (TLOGMGR) Adjacent Node
INITSELF ( ) or LOGON ( )
PSR (pludef1,TANLU1)
OPEN #LU1
In Figure C-7, a second application also succeeds in establishing a BIND with a remote
PLU.
In Figure C-8
, the INITSELF is rejected because no SNA name was defined during
configuration (see Table C-3).
SLU Accept Mode: Session Initiation
In the following figures, SNAX/APN has been configured according to Table C-4 for
SLU Accept mode. If you need more information about configuring SNAX/APN,
please refer to the SNAX/APN Configuration and Control Manual.
Figure C-7. SLU Acquire Mode of Operation: Second Application
Figure C-8. SLU Acquire Mode of Operation: Third Application
Table C-4. SCF Configuration For SLU Accept Mode
Subdevice Name LOCALSNANAME SNANAME
#LU1 tanlu1 Not Defined
#LU2 tanlu2 Not Defined
#LU3 tanlu3 Not Defined
C07CDT .CDD
Application #2
SNAX/APN (TLOGMGR) Adjacent Node
INITSELF ( ) or LOGON ( )
PSR (pludef1,TANLU1)
OPEN #LU1
C08CDT .CDD
Application #3
SNAX/APN (TLOGMGR) Adjacent Node
INITSELF or LOGON
OPEN #LU3
Reject: No SNA name has been configured