SNAX/APN Application Programming Manual

Introduction to SNAX/APN High-Level APIs
SNAX/APN Application Programming Manual—420111-001
1-7
Tandem PLU Accept
positive response from the device, the application can communicate directly with the
device by issuing other procedure calls.
Tandem PLU Accept
Tandem PLU accept requires XLF or ELF configuration depending on whether
SNAX/APN is acting as a LEN Node or End Node.
Tandem PLU Accept Using XLF with LEN or End Node
Before a Tandem PLU application in this environment can accept an LU-LU session
with a terminal or workstation device in an IBM network, the following conditions must
be satisfied:
•
The SNAX /APN service manager must be started
•
The SNAX Creator-2 application must be defined with a subordinate APPL for each
and every CRT or ITI application requiring logon from devices in the IBM network
Figure 1-3. Tandem PLU Acquire
103CDT .CDD
BIND Request
Tandem
Application
SNAX/APN
Tandem
System
3270
Terminal
IBM LU
VTAM
NCP
SNA Host
SNA Cluster
Controller
SNA Communication
Controller
OPEN
Remote LU
Object