SNAX/CNM Manual

INTRODUCTION
Verb/Reply Header
Reserved This designation indicates unused fields that
must be allocated in the WRITEREAD buffer.
CONNECT-ID CONNECT-ID is the integer value returned by a
REPLY^CONNECT in response to a VERB^CONNECT.
This value must be used in the header of
subsequent verbs.
VRB/REP Indicator 0 = verb; 1 = reply
POS/NEG Reply In verbs, your program sets this field to 0.
When the reply arrives, 0 = positive reply,
1 = negative reply.
Component ID In a VERB^CONNECT, this field must be 0. In
other verbs, this field indicates the $SSCP
component to which the verb is directed
(2 = CNM component, 3 = CONFIG
component). Except for the VERB^ACCEPT
(which can properly be directed to either
component), a verb can be directed to only
one component (as shown in the verb
description in Section 2, "Verb Directory").
Function This field varies from one verb to another.
To determine the value to be used in a given
verb, see the verb description in Section 2,
"Verb Directory."
Internal Error Use 0 on verbs. For positive replies,
this field is unchanged. For negative
replies, this field should be checked for
GUARDIAN 90 error codes. In addition to
other GUARDIAN 90 codes, the following codes
apply to network management functions:
Code Explanation
2600 nm^dataoverrun
2601 nm^internal^err
2602 nm^rsp^was^sent
2700 cs^dataoverrun
1-8