SNAX/CNM Manual

INTRODUCTION

Gathering Information at Remote Nodes

Statistical Counters

The CMI START LINE command resets the line counters, and the

CMI START PU command resets the physical unit counters. You can

reset either line or PU counters by using the CMI STATUS command,

which has the following syntax:

STATUS { LINE | PU }

object-name

, RESET

Your program can also reset these counters as an option of the

VERB^STATISTICS (see the STATISTICS entry in Section 2, "Verb

Directory," later in this manual). The CMI STOP LINE and STOP PU

commands do not reset the counters.

REQMS Modifier of the CMI ADD PU Command

In configuring a gateway line, use REQMS ON if $SSCP is to

respond to a host-generated ACTPU with RSP(ACTPU) format 1

(vector key H"07"). Use REQMS OFF if $SSCP is to respond with

format 0; thus, the host SSCP will not attempt to send REQMS

requests or NMVTs that request network information, because the

format 0 response to the ACTPU indicates that the PU does not

support FMD requests from the SSCP.

Note that the use of the REQMS modifier is the same whether your

application responds to REQMS or NMVTs.

For a primary line, the REQMS modifier has no effect.

1-15