SNAX/HLS Configuration and Control Manual

Command Dictionary
Using the HLSCOM Utility
6–8 104705 Tandem Computers Incorporated
ALTER Command The ALTER command changes various SNAX/HLS parameters and options.
ALTER [ keyword-and-value [, keyword-and-value ] ...]
keyword-and-value can be one of the following:
BACKUPCPU integer
adjusts the backup CPU. If integer is -1, the backup is stopped and not
restarted; otherwise, integer must be in the range 0 through 15.
BACKUPDEBUG yesno
adjusts the BACKUPDEBUG option. The possible values TRUE, YES, ON, or SET
all imply the option is turned on. FALSE, NO, OFF, or RESET all imply the option
is turned off.
CHARMAPFILE file-name
alters the name of the current charactermap file. This file defaults to
$SYSTEM.SYSTEM.ZCHARMAP. This file has only to be present if a charactermap
other than the standard ASCII-to-EBCDIC translation is to be employed. This
affects only sessions initiated subsequent to this command being issued.
CHARMAPNAME map-name
alters the name of the default charactermap table, which must exist in the current
charactermap file. The default map-name is originally set by the startup
parameter CHARMAPNAME, which itself defaults to the standard ASCII-to-
EBCDIC charactermap. (If any session is to use the standard ASCII–to–EBCDIC
translation, then this must be the process default. Any other process default
causes the standard translation to become unavailable.) This affects only sessions
initiated subsequent to this command being issued.
DEBUGONERROR yesno
adjusts the DEBUGONERROR option. The possible values ON, TRUE, YES, or
SET all imply the option is turned on. NO, FALSE, OFF, or RESET all imply the
option is turned off.
EMS collector-name
assigns a new primary EMS collector. collector-name must be the name of an
EMS collector.
EMS-1 collector-name
assigns a new alternate collector number 1. collector-name must be the name
of an EMS collector.