SNAX/HLS Configuration and Control Manual

Command Dictionary
Using the HLSCOM Utility
104705 Tandem Computers Incorporated 6–23
backup takeover occurred when the session was active, and that the application
should deallocate such a session. Such a session should not be terminated using
the ABORT command.
HS Plrty
Specifies the type of LU represented by this session ID. This field is either PLU
(primary LU) or SLU (secondary LU).
Open Mode
Specifies the open mode of the session. This field is either accept or acquire .
In accept processing, SNAX/HLS waits for session-partner contact; in acquire
processing, SNAX/HLS immediately attempts to contact the session partner.
Profile Name
Specifies the name of the PROFILE delivered from the SNAX/HLS application in
the OPEN-SESSION verb or the HLS-ALLOCATE verb.
Appl Name
Specifies the PLU name carried in the BIND request.
If the LU is type PLU, then the PLU name sent in the BIND is the name in the
APPLICATION-NAME field of the OPEN-SESSION or HLS-OPEN verb. If this
field is empty, then the PLU-NAME in the BIND record in the RDT table is used.
If the LU type is PLU and the open mode is ACCEPT, the APPLICATION-NAME
field in the open verb is empty, and there is no PLU-NAME in the BIND record in
the RDT table, the DLU name in the INIT-SELF is sent as the PLU name in the
BIND request.
Max Req
Specifies the value of the profile’s MAX-REQUESTS attribute field. This is the
maximum number of verbs that can be queued by SNAX/HLS for this session.
Xlate Ind
Indicates the status of SNAX/HLS translation. If yes is shown, the SNAX/HLS
server is translating session data. If no is shown, the SNAX/HLS server is not
translating session data. Note that this setting might interact with any translation
being done by the Tandem SNA access method (SNAX/XF or SNAX/CDF).
LMO
Indicates the status of large message option (LMO) for the session. (See the
SNAX/HLS Application Programming Manual for more information on LMO.)
If the DETAIL keyword is specified, a lengthier printout is produced. It consists of
two main sections:
Application interface PROFILE