SNAX/HLS Configuration and Control Manual

Command Dictionary
Using the HLSCOM Utility
6–28 104705 Tandem Computers Incorporated
Figure 6-4. Example of LISTOPENS Display
HLS Application (backup)
$TALREQ PID 4,23
$SNA1.#LU2
$ZNET
SCP
PID 2,12
HLSCOM
HLS Application
$TALREQ PID 3,34
SNAX/HLS
@ listopens *.*
Primary Backup
Session Process CPU/ CPU/ Open
Name Name FN PIN FN PIN Name
------------------------------------------------------
$SNA1.#LU2 $TALREQ 3 3,34 3 4,23 #SNA1.LU2
@ listopens
Primary Backup
Process CPU/ CPU/ Open
Name FN PIN FN PIN Name
------------------------------------------------------
$TALREQ 3 3,34 3 4,23 #SNA1.LU2
$ZNET 3 2,12 #ZSPI
The LISTOPENS display should be interpreted as follows:
Session Name
specifies the name of the LU being used by this session ID (SSID). When using *.*
as the LU specifier, the session name may appear in lowercase. This indicates that
a backup takeover occurred when the session was active and that the application
should deallocate such a session. It also indicates the session whose openers or
allocators are being reported. The application program should deallocate the
session resources because they are no longer needed.