SNAX/HLS Configuration and Control Manual

Command Dictionary
Using the HLSCOM Utility
104705 Tandem Computers Incorporated 6–37
Version
Specifies the complete version banners of all software components inside
SNAX/HLS, not HLSCOM.
Resource Definition Table Section
RDT File
Specifies the file name of the current RDT database and the modification time
stamp of the file.
Compiled By
Specifies the version banner of the RDT compiler that created the above RDT
database.
Configuration Section
Program File
Specifies the program file name and modification date of the SNAX/HLS process.
Library File
Specifies the program file name and modification date of the library file. This line
is omitted if the customization routine in the system library is being used.
Log File
Specifies the name of the LOG file to which log messages are being sent. This line
is omitted if no LOG file is currently defined.
EMS Collector
Specifies the process name of the primary EMS collector to which events are being
sent. This line is omitted if no EMS collector is currently defined.
EMS Collector n
Specifies the process name of the alternate EMS collector n, where n is 1, 2, or 3.
There is one such entry for each active alternate EMS collector. This line is omitted
if no alternate EMS collector is currently defined.
Message File
Specifies the name and modification date of the messages file currently being used
by SNAX/HLS.
Buffer Swap Volume
Specifies the name of the disk being used to swap the normal data area. This is
controlled by the SWAP run option at startup.