SNAX/HLS Configuration and Control Manual

Command Dictionary
Using the HLSCOM Utility
104705 Tandem Computers Incorporated 6–39
Customizer Section
Is present only if the customization routines are enabled.
Exits Enabled
Lists those routines that are enabled by one or more of the following keywords:
VERB-IN
VERB-OUT
SNAX-IN
SNAX-OUT
VRFY-BIND
VRFY-STSN
Buffer Size
Specifies the amount of storage, in bytes, allocated for the use of the customization
routines.
CharacterSet Section
This section is present if the default character mapping file
$SYSTEM.SYSTEM.ZCHARMAP exists, or a character mapping file has been configured
using either the CHARMAPFILE startup parameter or the HLSCOM ALTER
command.
CHARMAP File
This is the current character map file for the SNAX/HLS process and its
modification time.
Compiled By
This is the compilation banner for the above file.
Table Name
This is the name of the default charactermap table for the process. This is only
present if the default charactermap table for the SNAX/HLS process is not the
standard ASCII-to-EBCDIC translation.
Table Notes
This note describes the above table, and is obtained from the charactermap file.
This is only present if the default charactermap table for the SNAX/HLS process is
not the standard ASCII-to-EBCDIC translation.
Tracing Section
This entire section is listed only if a trace file is assigned. The Default Trace Flags is
present if the INITIAL^TRACE configuration parameter is specified at startup.