SNAX/HLS Configuration and Control Manual

Command Dictionary
Using the HLSCOM Utility
6–44 104705 Tandem Computers Incorporated
STATUS Command The STATUS command provides summary information on the dynamic state of
SNAX/HLS sessions. If the DETAIL option is used on this command, state and
control information is included.
STATUS LU-specifier [ , DETAIL ]
LU-specifier
is a LU specifier in one of the basic forms. See the “Basic Components” discussion
for information on LU-specifier.
DETAIL
is a keyword to include extensive diagnostic information in the display.
Examples
FS shows a sample display from the STATUS command.
Figure 6-6. Example of STATUS Display
@status *.*
Session Status Trace Verb Sense Data
Id Name Flags Code Send Recv
------------------------------------------------------------------------------
3 $SNA1.#P1L1 STARTED (No verb) 0000 0000 0000 0000
4 $SNA1.#P1L2 STARTED (No verb) 0000 0000 0000 0000
1 $SNA2.#P1L1 STARTED (No verb) 0000 0000 0000 0000
2 $SNA2.#P1L2 STARTED (No verb) 0000 0000 0000 0000
@status $sna1.#p1l1,detail
Session Status Trace Verb Sense Data
Id Name Flags Code Send Recv
------------------------------------------------------------------------------
3 $SNA1.#P1L1 STARTED (No verb) 0000 0000 0000 0000
- - - - - - - - - - - - - - - - State information - - - - - - - - - - - - -
Session active Cbsm_Rsp_R not_in_use CBsm_Rsp_S reset
Data Traf active Chdx_Rsp_R not_in_use Chdx_Rsp_S reset
Shutdown reset Chain_Send betc Chain_Rcv betc
Bracket betb QEC_Send not_in_use QEC_Rcv not_in_use
Send/Rcv cont EBCD_Send reset EBCD_Rcv reset
RTR_State reset SBI_Send not_in_use SBI_Rcv not_in_use
STSN_State reset IMM_RQ_Send reset IMM_RQ_Rcv reset
- - - - - - - - - - - - - - - Control Information - - - - - - - - - - - - - - -
Allocators: 1 Openers: 1
Work Queue Pacing Correl Seqno
RECV: 0 0 0 0 0
SEND: 0 0 0 0 0
The information displayed in the STATUS reply is described in the following
subsections.