SNAX/HLS Configuration and Control Manual

Command Dictionary

Using the HLSCOM Utility

6–60 104705 Tandem Computers Incorporated

SYSTEM Command The SYSTEM command is used to set the default system for all file–name expansions.

The SYSTEM command is equivalent to entering a CMDSYS command and an

OBEYSYS command, both with the same

system-name

specification.

SYSTEM [ \

system-name

]

system-name

is a system name. The initial setting is the default system name used by the

command interpreter when HLSCOM is started.

system-name

is omitted, the default system name is cleared, thus permitting

reference to seven-character local device names that are too long to reference in

network form.

Examples

The following command

@ SYSTEM \FTWORTH

is equivalent to the following two commands.

@ CMDSYS \FTWORTH

@ OBEYSYS \FTWORTH

The following command clears the default system name:

@ SYSTEM