SNAX/HLS Configuration and Control Manual

Command Dictionary
Using the HLSCOM Utility
104705 Tandem Computers Incorporated 6–63
This command adds the SNAX/HLS session #LU4 (qualified with the current default
line-name set by the ASSUME command) to the ETT. All calls to the data flow
control layer of SNAX/HLS are traced.
@ TRACE ENABLE #LU4,TYPE D
This command adds all SNAX/HLS sessions on line-name $SNA2 to the ETT. The
trace information saved includes all verb interfaces and all calls to the logical unit
service manager in SNAX/HLS.
@ TRACE ENABLE $SNA2.*,TYPE V,L
This command removes the single session $SNA2.#LU3 from the ETT.
@ TRACE DISABLE $SNA2.#LU3
This command directs the SNAX/HLS server to stop trace activities and close the trace
file. Trace analysis is now possible using the SNAX/HLS Trace Analysis Program
(HLSTAP) described in the SNAX/HLS Diagnosis and Support Manual.
@ TRACE STOP