SNAX/HLS Configuration and Control Manual

Appendix B HLSCOM Error Messages
104705 Tandem Computers Incorporated B–1
This appendix contains HLSCOM error messages.
In general, the HLSCOM error messages that report SPI or token-in-error messages
occur when your command was syntactically correct, its parameters passed all validity
checks, but through a typing mistake or some other error, the command indicated the
wrong object.
The error messages listed in Table B-1 are SPI messages that could have been caused
by a processor switch, a process failure, or an internal programming error. If you see
these error messages and know that no processor switch or process failure occurred,
gather the information recommended in Section 1 of the SNAX/HLS Diagnosis and
Support Manual and call your Tandem analyst.