SNAX/HLS Configuration and Control Manual

HLSCOM Error Messages
B–4 104705 Tandem Computers Incorporated
Failure accessing trace file
Cause. The SNAX/HLS server could not access the trace file because of a file-system
error.
Effect. The command fails.
Recovery. See if the trace file exists and check its security. When you have corrected
the situation, reissue the command.
Invalid duplicate use of token token
Cause. The HLSCOM program used the same token twice in the same command
where the command does not allow this token to be used twice in the same command.
Effect. The command fails.
Recovery. Correct the command and reissue it.
No default line name is defined
Cause. You specified a LU by using only the LU-name portion, expecting that the
command interpreter would apply the current default line name. However, there is no
such current default.
Effect. The command fails.
Recovery. Include the line name in the command or use the ASSUME command to
establish a default line name.
No objects of type obj-typ e matching obj-nam e were found
Cause. HLSCOM could not find any objects matching obj-name that had the type
obj-type .
Effect. The command fails.
Recovery. Correct the object name template in your command and reissue the
command. (This provides information only if you issue a STATUS *.* command and
no sessions are currently allocated.)