SNAX/HLS Configuration and Control Manual

Appendix C HLSRDT Error Messages
104705 Tandem Computers Incorporated C–1
The following error messages are generated by the HLSRDT program.
An object by that name does not exist
Cause. You have referenced an object that has not been added.
Effect. The command fails.
Recovery. Correct any wrong names, or misspellings of the object name, and reissue
the command.
An object of the same name already exists
Cause. You attempted to add an object with a name that already exists.
Effect. The command fails.
Recovery. Check the command and retry with a different object name.
Required BIND name missing
Cause. The PROFILE entry you are trying to add is a primary PROFILE and needs a
BIND image name, but you didn’t specify it.
Effect. The command fails.
Recovery. Give the PROFILE a BIND name and then add the profile.
Required INIT name missing
Cause. The PROFILE entry you are trying to add is a secondary acquire PROFILE and
needs an INIT image name, but you didn’t specify it.
Effect. The command fails.
Recovery. Give the PROFILE an INIT name and then add the PROFILE.